Email Detail

HTTP 200 OK
Allow: GET, HEAD, OPTIONS
Content-Type: application/json
Vary: Accept

{
    "url": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/23WUAAFJVXKI4N3LC2VVW7FMWACVXDCP/",
    "mailinglist": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/",
    "message_id": "4E17D2EFF6A74A02B7FBE78B0704D36E@BlackPC",
    "message_id_hash": "23WUAAFJVXKI4N3LC2VVW7FMWACVXDCP",
    "thread": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/thread/23WUAAFJVXKI4N3LC2VVW7FMWACVXDCP/",
    "sender": {
        "address": "k.swaggart (a) charter.net",
        "mailman_id": "b53f0c8256f444dea314ac1412cd4bd5",
        "emails": "https://mailman.amsat.org/hyperkitty/api/sender/b53f0c8256f444dea314ac1412cd4bd5/emails/"
    },
    "sender_name": "Ken Swaggart",
    "subject": "[amsat-bb] E1P telemetry reception",
    "date": "2011-11-09T22:40:36Z",
    "parent": null,
    "children": [],
    "votes": {
        "likes": 0,
        "dislikes": 0,
        "status": "neutral"
    },
    "content": "Finally worked out the bugs in my receiving setup for E1P.  My antenna is \nonly a 70 cm HO loop with a mast mounted preamp. Haven't yet repaired the \nG-5500 (Yaesu hasn't responded to my queries!).  Surprisingly, that antenna \nworks quite well for E1P.  Here's how I configured my equipment:\n\nReceiver Mode: LSB\nFreq: 437.5017  at pass start (excluding Doppler) drifting down to \n437.50110. This could either be due to a slight error in the keps, or drift \nin the satellite's transmitter.  This requires manual tweaking of the \nreceiver in addition to Doppler correction. I tuned the receiver so the 1 \nsecond tuning tone from E1P was at the upper 1200 baud packet marker in \nMixW.\n\nDemodulator:  MixW set at normal 1200 baud packet. Using a virtual serial \nport emulator to connect to the E1P telemetry decoder.  Also fed the audio \nto a KPC-9612, but was not able to decode any packets, even though MixW was \nhaving no problem with the signal.\n\nI'm really amazed that I could collect data from a cube sat using my omni \nantenna!  So far my best (in two passes) was 23 decoded telemetry frames.\n\nKen, W7KKE\nCN75xa\n\n\n\n\n",
    "attachments": []
}