Email Detail

HTTP 200 OK
Allow: GET, HEAD, OPTIONS
Content-Type: application/json
Vary: Accept

{
    "url": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/4IZD5B7WRRPJVH7KHUPXQ4OMYMVQHODM/?format=api",
    "mailinglist": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/?format=api",
    "message_id": "[email protected]",
    "message_id_hash": "4IZD5B7WRRPJVH7KHUPXQ4OMYMVQHODM",
    "thread": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/thread/YPJ6CZHKUVS7N3M5KQE6FDQTGGNAE342/?format=api",
    "sender": {
        "address": "ve9qrp (a) gmail.com",
        "mailman_id": "4d6061838db34aba9a1c4722addebfaf",
        "emails": "https://mailman.amsat.org/hyperkitty/api/sender/4d6061838db34aba9a1c4722addebfaf/emails/?format=api"
    },
    "sender_name": "Bruce Robertson",
    "subject": "[amsat-bb] Re: Rigblaster TNC?",
    "date": "2009-09-09T12:55:53Z",
    "parent": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/RQOYQZF4ZFLDK6KD3YSOLOOAD4R4T4NL/?format=api",
    "children": [],
    "votes": {
        "likes": 0,
        "dislikes": 0,
        "status": "neutral"
    },
    "content": "On Wed, Sep 9, 2009 at 9:20 AM, Alan P. Biddle<[email protected]> wrote:\n> John,\n>\n> A rigblaster is an interface only, but can be used with the correct software\n> as a TNC for most digital modes.  I use MixW which emulates a basic TNC,\n> including a KISS mode output which works with all the programs I have tried\n> which expect to see a KISS TNC.  There is another program, Packet Engine\n> Pro, which works well as long as you only want the basic packet modes.\n> There is also a freeware version.\n>\n> Note that while MixW will work at 9600 baud, the rigblaster will probably\n> not.  The isolation transformers found in all good interfaces will not pass\n> the range of frequencies needed at 9600 baud and up.  In principle you could\n> build an interface that would word, but all those who have reported success\n> using MixW or similar at 9600 baud go directly from the sound card to the\n> rig.\n>\n> Alan\n> WA4SCA\n\nI concur with Alan, but I also note that this summer I was able to get\nMixW to decode 9600 baud from my TS-2000 using a Signalink 1+ as a\nsound card interface. I'd tried this on-and-off over the past year and\na half and was surprised to see it work. (Folks may wonder why I went\nthe soundcard route when the TS-2000 has a 9600 modem built in. This\nis because you cannot use the serial port on the TS-2000 to act as a\nTNC and for rig control. To automate my station, I require rig control\nand therefore software data decoding.)\n\n73, Bruce\nVE9QRP\n\n",
    "attachments": []
}