Email Detail

HTTP 200 OK
Allow: GET, HEAD, OPTIONS
Content-Type: application/json
Vary: Accept

{
    "url": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/4X4OU3T7KOZUZDOUGKEM4YYUUJMBH7ET/?format=api",
    "mailinglist": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/?format=api",
    "message_id": "[email protected]",
    "message_id_hash": "4X4OU3T7KOZUZDOUGKEM4YYUUJMBH7ET",
    "thread": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/thread/GT7VLS4XAMHAZBZZ4V5D5N2QHHDHS44K/?format=api",
    "sender": {
        "address": "hamoen (a) iae.nl",
        "mailman_id": null,
        "emails": null
    },
    "sender_name": "Henk, PA3GUO",
    "subject": "[amsat-bb] Re: Making your own rotator controller",
    "date": "2007-12-31T13:52:24Z",
    "parent": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/262D25BEWU5KNPD3RX62QPRY2WPED4JX/?format=api",
    "children": [],
    "votes": {
        "likes": 0,
        "dislikes": 0,
        "status": "neutral"
    },
    "content": "Yes !\n\nNow I remember I also needed to implement this (but <16).\nI have done this inside the ST6, as sending via rs232 also took time.\n\nA capacitor would have had my preference, but I never thought about that.\nGood suggestion.\n\nWe are getting to a complete overview here !\n(too bad I did not properly document this back then ...)\n\nHenk\n\n\n> In the LVB tracker I average sixteen or so ADC samples over time to get some kind of sensible value. Either that or\n> I could pop a 10uF cap on the Az/El PIC ADC inputs, but software was cheaper.\n>\n> 73, Howard G6LVB\n>\n\n\n\n",
    "attachments": []
}