Email Detail

HTTP 200 OK
Allow: GET, HEAD, OPTIONS
Content-Type: application/json
Vary: Accept

{
    "url": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/EBCO2SUHXJBCRLN3LTT6EXE4KY4UJI5F/",
    "mailinglist": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/",
    "message_id": "[email protected]",
    "message_id_hash": "EBCO2SUHXJBCRLN3LTT6EXE4KY4UJI5F",
    "thread": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/thread/EBCO2SUHXJBCRLN3LTT6EXE4KY4UJI5F/",
    "sender": {
        "address": "doomsdaymike (a) netzero.com",
        "mailman_id": null,
        "emails": null
    },
    "sender_name": "mike casey",
    "subject": "[amsat-bb]  ICOM 471A Output N Connector replacement",
    "date": "2010-06-15T06:16:31Z",
    "parent": null,
    "children": [],
    "votes": {
        "likes": 0,
        "dislikes": 0,
        "status": "neutral"
    },
    "content": "Has anyone replaced the female N connector on the IC 471A, 25 watt tranceiver PA module? It seems as if the heat sink is trapped between the N connector barrel and the PA circuit board. Unless the connector barrel pulls off of the pin, I see no way of removing it, or the circuit board to get at the pin. I don't want to use to much force in pulling off the barrel. Perhaps heating the pin might release the barrel. Any suggestions? Should I send it to Icom and let them worry about it?\n____________________________________________________________\nArtery Clearing Secret\nNobel Prize Winning discovery cuts artery plaque by incredible 50%.\nhttp://thirdpartyoffers.netzero.net/TGL3241/4c171b0a911a53e57d6st02duc\n",
    "attachments": []
}