Email Detail

HTTP 200 OK
Allow: GET, HEAD, OPTIONS
Content-Type: application/json
Vary: Accept

{
    "url": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/KX6C2IRUGA6Z3DIQNJYF537M6CM6N7A4/?format=api",
    "mailinglist": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/?format=api",
    "message_id": "[email protected]",
    "message_id_hash": "KX6C2IRUGA6Z3DIQNJYF537M6CM6N7A4",
    "thread": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/thread/KX6C2IRUGA6Z3DIQNJYF537M6CM6N7A4/?format=api",
    "sender": {
        "address": "s.wilson (a) yahoo.com",
        "mailman_id": null,
        "emails": null
    },
    "sender_name": "Scott Wilson",
    "subject": "[amsat-bb]  ARRL dual moxon turnstyle project questions",
    "date": "2007-07-31T14:08:16Z",
    "parent": null,
    "children": [
        "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/J32KPVQDUVKJPVLF43PM5XGTG74WS7IY/?format=api"
    ],
    "votes": {
        "likes": 0,
        "dislikes": 0,
        "status": "neutral"
    },
    "content": "I'm working on building the ARRL dual moxon antennas, but the article\nisn't very detailed where I'd like it to be and a little over detailed in\nsome places I wish it weren't.\n\nIf you want to look, this is the URL\n(http://www.arrl.org/members-only/tis/info/pdf/0108038.pdf)\n\n1. What are acceptable ways to terminate the paralled 75 ohm matching\nsections? I'm thinking now I'll just terminate them to a couple of ring\nterminals attached to the mast rather than terminating each one with a bnc\nand teeing them.\n\n2. How do I feed the 70cm and 2m with the same feedline? should I just tee\na 50 ohm line to two equal length 50 ohm sections?\n\n3. This is more of a comment... I'm wagering the uhf version doesn't work\nat all... measurements are given to the hundreth of an inch - and then you\nsolder a big ring lug to the end of it!\n\n4. Are there any other good techniques for setting the distance between\nthe reflector and driver besides heat shrink?\n\nThe 70cm antenna is using #14 galvanized wire, and I can't think of\nanything small enough to hold them in place well. I found that the 3/16\nrod for the 2m moxon will work great with 1/4\" nylon tubing.\n\nThanks for any feedback - I'll probably have more questions.. I'm sitting\nhere with a half-made 70cm turnstyle, and am about to start on the 2m\nversion.\n\nWhew - I'm beginning to think that a $1000 investment in rotators and\nantennae isn't such a bad idea after all!\n\nScott Wilson\nNW2S\n\n",
    "attachments": []
}