Email Detail

HTTP 200 OK
Allow: GET, HEAD, OPTIONS
Content-Type: application/json
Vary: Accept

{
    "url": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/L7BEUKKSLJHRWXUQXWK5P7DE7ZM5HEYL/?format=api",
    "mailinglist": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/?format=api",
    "message_id": "016a01c931f3$dc220200$0200a8c0@Tanguray",
    "message_id_hash": "L7BEUKKSLJHRWXUQXWK5P7DE7ZM5HEYL",
    "thread": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/thread/JYLFJ3DCNKY67HVODWW5OKSVFIQRTKV3/?format=api",
    "sender": {
        "address": "rogerkola (a) aol.com",
        "mailman_id": "8323dbe496014835b5bd2be9b5ff6f66",
        "emails": "https://mailman.amsat.org/hyperkitty/api/sender/8323dbe496014835b5bd2be9b5ff6f66/emails/?format=api"
    },
    "sender_name": "Roger Kolakowski",
    "subject": "[amsat-bb] Re: beginner question re: uplink power",
    "date": "2008-10-19T14:06:16Z",
    "parent": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/JYLFJ3DCNKY67HVODWW5OKSVFIQRTKV3/?format=api",
    "children": [
        "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/2WYHNFGYKMNQNIERYO6TWRROUQRBAUQT/?format=api"
    ],
    "votes": {
        "likes": 0,
        "dislikes": 0,
        "status": "neutral"
    },
    "content": ">My initial investment is minimal\n\n>When I assemble the RF switches I must choose a RF\n>range....The range is determined by the\n> choice of a specific resistor.  The default three >ranges suggested are\n> 0-10 watts, 10-30 watts, and 30-100 watts.\n\nThe answer is actually in what transmitters or power amplifiers are you\nplanning to use that fit within your budget?\n\nWatts cost money...\n\nWith a limited gain omnidirectional you might best aim toward the middle\nrange but if you are looking at used SSB/CW equipment at 430, many of the\nless expensive older radios only ran 10 watts out. Of course a \"Linear\nAmplifier\" for SSB/CW could move you up but is not necessarily inexpensive.\n\nYou might want to just accept the fact that you may need to \"climb the\ntower\" again once you settle on your transmitters.\n\nRoger\nWA1KAT\n\nSent: Sunday, October 19, 2008 1:30 AM\nSubject: [amsat-bb] beginner question re: uplink power\n\n\n> hello,\n>\n\nMy initial investment is minimal\n\nWhen I assemble the RF switches I must choose a RF\nrange....The range is determined by the\n> choice of a specific resistor.  The default three ranges suggested are\n> 0-10 watts, 10-30 watts, and 30-100 watts.\n\n",
    "attachments": []
}