Email Detail

HTTP 200 OK
Allow: GET, HEAD, OPTIONS
Content-Type: application/json
Vary: Accept

{
    "url": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/MC4FYSPJ5FQICMDFYJCJZ5GEKWHEESBS/",
    "mailinglist": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/",
    "message_id": "Pine.SOL.3.95.1060820223401.19834A-100000@bookworm",
    "message_id_hash": "MC4FYSPJ5FQICMDFYJCJZ5GEKWHEESBS",
    "thread": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/thread/UJ4VXVB5CFN2EIPPF4VUPLWA5DBYCJOI/",
    "sender": {
        "address": "tmcgrane (a) suffolk.lib.ny.us",
        "mailman_id": null,
        "emails": null
    },
    "sender_name": "McGrane",
    "subject": "[amsat-bb] Re: Mirage Preamp Setting",
    "date": "2006-08-21T02:37:48Z",
    "parent": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/UJ4VXVB5CFN2EIPPF4VUPLWA5DBYCJOI/",
    "children": [],
    "votes": {
        "likes": 0,
        "dislikes": 0,
        "status": "neutral"
    },
    "content": "\nHi again richard- wrote faster than I thought- the higher gain reduces\nselectivity. Bottom line: if you have good seperation of antennas, try\nthe high setting. If you run alot of power ; low.\nthanks again for the contact, pat n2oeq\n\n\nOn Sun, 20 Aug 2006, Richard Lawn wrote:\n\n> I'm about to mast mount a new Mirage 70cm preamp. It has a high/low setting.\n> Any suggestions from the group as I'm sure many of you are using this\n> preamp. Is the high setting too much gain? I got tired of forgetting I had\n> the ARR preamp on an frying it by sending too much RF into it.\n> 73\n> Rick\n> W2JAZ\n> \n> Richard Lawn, Dean\n> College of Performing Arts\n> University of the Arts\n> 215-717-6125\n> \n> \n> \n> \n> _______________________________________________\n> Sent via [email protected]. Opinions expressed are those of the author.\n> Not an AMSAT-NA member? Join now to support the amateur satellite program!\n> Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb\n> \n\n",
    "attachments": []
}