Email Detail

HTTP 200 OK
Allow: GET, HEAD, OPTIONS
Content-Type: application/json
Vary: Accept

{
    "url": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/NZ7BXVKCADJI2Y5XCEWK7WNYKKPYSZQO/?format=api",
    "mailinglist": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/?format=api",
    "message_id": "[email protected]",
    "message_id_hash": "NZ7BXVKCADJI2Y5XCEWK7WNYKKPYSZQO",
    "thread": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/thread/NZ7BXVKCADJI2Y5XCEWK7WNYKKPYSZQO/?format=api",
    "sender": {
        "address": "john (a) papays.com",
        "mailman_id": "40c82fe75f644d01882ed3a91ae267dd",
        "emails": "https://mailman.amsat.org/hyperkitty/api/sender/40c82fe75f644d01882ed3a91ae267dd/emails/?format=api"
    },
    "sender_name": "John Papay",
    "subject": "[amsat-bb]  SO-67 Suggestions",
    "date": "2010-06-30T17:00:52Z",
    "parent": null,
    "children": [],
    "votes": {
        "likes": 0,
        "dislikes": 0,
        "status": "neutral"
    },
    "content": "SO-67 is in a mode whereby the uplink audio is\nrepeated as long as the transmitter is turned on.\nIf there is no PL on the uplink, repeated audio\nwill be reduced by about 10db compared to rx noise\nwhen no satellite is in view. SO-67 is being turned\non for 15 minute periods as conditions permit.\n\nIf you transmit PL, the repeated audio level will\nbe 10db higher than with no PL, however the PL tone\nlevel will also be very high.  There is apparently no tone\nfiltering between the receiver and the transmitter.\n\nOnce you stop transmitting with PL, you will hear rx\nnoise at full deviation.  After 2-1/2 seconds or so,\nthe repeated noise/audio level will once again be 10db down.\n\nAs mentioned in another post, the best way to operate\ngiven this configuration is not to use PL and work with\nthe low audio.  Since this bird is very strong, low audio\nis not a big problem.  If there are signals with PL, the\naudio level will jump up 10db so watch your ears.\n\n73,\nJohn K8YSE\n\n",
    "attachments": []
}