Email Detail
Show an email
GET /hyperkitty/api/list/[email protected]/email/QM4DJADDSAKE74GKHL5S6X5ZM5SNMQLA/?format=api
{ "url": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/QM4DJADDSAKE74GKHL5S6X5ZM5SNMQLA/?format=api", "mailinglist": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/?format=api", "message_id": "[email protected]", "message_id_hash": "QM4DJADDSAKE74GKHL5S6X5ZM5SNMQLA", "thread": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/thread/QM4DJADDSAKE74GKHL5S6X5ZM5SNMQLA/?format=api", "sender": { "address": "zl3custarr (a) gmail.com", "mailman_id": "53217958fb3c4709bf0d5f856008fbb1", "emails": "https://mailman.amsat.org/hyperkitty/api/sender/53217958fb3c4709bf0d5f856008fbb1/emails/?format=api" }, "sender_name": "Starr Moffatt", "subject": "[AMSAT-BB] Re: IO-117 question", "date": "2023-03-16T07:55:53Z", "parent": null, "children": [], "votes": { "likes": 0, "dislikes": 0, "status": "neutral" }, "content": "Hi Alex,\n\nYes I have noticed that I can often access the satellite with 5 watts \nwhen it is near the horizon where there is little or no activity. \nHowever when there are a number of active stations it becomes difficult \nto access with 50 Watts. I would think that you would have more success \nif you tried during unsociable hours:-)\nGL\n73\nStarr ZL3CU\n\nOn 16/03/2023 7:37 pm, Fernando Ramirez via AMSAT-BB wrote:\n> Good evening Alex!\n> \n> The main issue during day passes is the overcrowding. When it comes from \n> the south you will notice that it is easy to get digipeated since a big \n> part of the Continental US will be outside the footprint. Once the \n> satellite enters higher latitudes you'll notice that is harder to get \n> through. Once the footprint hits Europe and US is inside it, start \n> praying but don't go crazy with the send button as it will make things \n> worst.\n> \n> As for the delay I always recommend keeping it at 0 unless you have some \n> kind of preamp that goes offline for several seconds. If the satellite \n> doesn't pick you up it won't matter if you set it to 5, to 0 or to 1000.\n> \n> Best of luck from Nogales! 73\n> \n> Fernando KF7R\n> \n> On Wed, Mar 15, 2023, 3:56 PM alex weimer via AMSAT-BB \n> <[email protected] <mailto:[email protected]>> wrote:\n> \n> __\n> Thanks Sergei: I was worried maybe my antenna didn't have enough\n> gain but I hear the satellite very well. That is a relief and thanks\n> for sharing the info with me., Just have to be patient I suppose\n> 73 JACK KC7MG\n> \n>> On March 15, 2023 at 6:31 PM Sergei Stepanov <[email protected]\n>> <mailto:[email protected]>> wrote:\n>>\n>> Hi Alex,\n>> It’s common problem on GreenCube indeed because rx is overcrowded.\n>> Try different ReTX Delay. 5, for example. Because most of all set 0.\n>> Tonight I was roving to KO39 and it was quite impossible to break\n>> through wall also.\n>>\n>> Best 73 de ES4RM, Sergei\n>>\n>> Sent from my iPhone\n>>\n>>> On 16. Mar 2023, at 00:28, Sergei Stepanov <[email protected]\n>>> <mailto:[email protected]>> wrote:\n>>>\n>>> Hi Alex,\n>>> It’s common problem on GreenCube indeed because rx is\n>>> overcrowded. Try different ReTX Delay. 5, for example. Because\n>>> most of all set 0.\n>>> Tonight I was roving to KO39 and it was quite impossible to break\n>>> through wall also.\n>>>\n>>> Best 73 de ES4RM, Sergei\n>>>\n>>> Sent from my iPhone\n>>>\n>>>> On 15. Mar 2023, at 23:12, alex weimer via AMSAT-BB\n>>>> <[email protected] <mailto:[email protected]>> wrote:\n>>>>\n>>>> \n>>>>\n>>>> I am having a peculiar problem when operating IO-117 (Greencube)\n>>>> When on an Ascending pass (South to Borth) I can hear the\n>>>> satellite very well but cannot access the digipeater! It makes\n>>>> no difference whether it is at 5 degrees or 50 degrees and\n>>>> whether the satellite is coming up from 180 or 030 degrees. I\n>>>> have no obstructions throughout these passes ! However when on a\n>>>> Descending pass (North to South) I can hear it as well as access\n>>>> the digipeater without any problems. I am running a IC9700 with\n>>>> a 14 element yagi horizontally polarized. I have 75 watts\n>>>> available and using the built in sound card from the IC9700 and\n>>>> the IO-117 modem and digi software from UZ7HO. Is there any\n>>>> reasonable explanation or is anyone else experiencing this\n>>>> problem? It has been frustrating to be able to see the DX\n>>>> stations and not be able to work them. Thanks for any help or\n>>>> suggestions on this matter.\n>>>>\n>>>> JACK KC7MG\n>>>>\n>>>>\n>>>> -----------------------------------------------------------\n>>>>\n>>>> Sent via AMSAT-BB(a)amsat.org <http://amsat.org>. AMSAT-NA makes\n>>>> this open forum available\n>>>> to all interested persons worldwide without requiring\n>>>> membership. Opinions expressed\n>>>> are solely those of the author, and do not reflect the official\n>>>> views of AMSAT-NA.\n>>>> Acceptable Use and Privacy Policies available at\n>>>> https://www.amsat.org/about-amsat/\n>>>> <https://www.amsat.org/about-amsat/>\n>>>>\n>>>> View archives of this mailing list at\n>>>> https://mailman.amsat.org/hyperkitty/list/[email protected]\n>>>> <https://mailman.amsat.org/hyperkitty/list/[email protected]>\n>>>> To unsubscribe send an email to amsat-bb-leave(a)amsat.org\n>>>> <http://amsat.org>\n>>>> Manage all of your AMSAT-NA mailing list preferences at\n>>>> https://mailman.amsat.org <https://mailman.amsat.org>\n> \n> \n> -----------------------------------------------------------\n> \n> Sent via AMSAT-BB(a)amsat.org <http://amsat.org>. AMSAT-NA makes\n> this open forum available\n> to all interested persons worldwide without requiring membership.\n> Opinions expressed\n> are solely those of the author, and do not reflect the official\n> views of AMSAT-NA.\n> Acceptable Use and Privacy Policies available at\n> https://www.amsat.org/about-amsat/ <https://www.amsat.org/about-amsat/>\n> \n> View archives of this mailing list at\n> https://mailman.amsat.org/hyperkitty/list/[email protected]\n> <https://mailman.amsat.org/hyperkitty/list/[email protected]>\n> To unsubscribe send an email to amsat-bb-leave(a)amsat.org\n> <http://amsat.org>\n> Manage all of your AMSAT-NA mailing list preferences at\n> https://mailman.amsat.org <https://mailman.amsat.org>\n> \n> \n> \n> -----------------------------------------------------------\n> \n> Sent via AMSAT-BB(a)amsat.org. AMSAT-NA makes this open forum available\n> to all interested persons worldwide without requiring membership. Opinions expressed\n> are solely those of the author, and do not reflect the official views of AMSAT-NA.\n> Acceptable Use and Privacy Policies available at https://www.amsat.org/about-amsat/\n> \n> View archives of this mailing list at\n> https://mailman.amsat.org/hyperkitty/list/[email protected]\n> To unsubscribe send an email to amsat-bb-leave(a)amsat.org\n> Manage all of your AMSAT-NA mailing list preferences at https://mailman.amsat.org\n", "attachments": [] }