Email Detail

HTTP 200 OK
Allow: GET, HEAD, OPTIONS
Content-Type: application/json
Vary: Accept

{
    "url": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/S2TX3OLL2LWQ3KSAKJWN5UVCJZPU4DZB/?format=api",
    "mailinglist": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/?format=api",
    "message_id": "[email protected]",
    "message_id_hash": "S2TX3OLL2LWQ3KSAKJWN5UVCJZPU4DZB",
    "thread": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/thread/S2TX3OLL2LWQ3KSAKJWN5UVCJZPU4DZB/?format=api",
    "sender": {
        "address": "rdwelch (a) swbell.net",
        "mailman_id": "74c268e9c7f9425986d05d525c9b5468",
        "emails": "https://mailman.amsat.org/hyperkitty/api/sender/74c268e9c7f9425986d05d525c9b5468/emails/?format=api"
    },
    "sender_name": "Roy",
    "subject": "[amsat-bb] Re: Surface Mount Repair",
    "date": "2007-11-04T23:27:57Z",
    "parent": null,
    "children": [],
    "votes": {
        "likes": 0,
        "dislikes": 0,
        "status": "neutral"
    },
    "content": "Hi again Guys,\n\nSuccess!  Thanks to all the replies I got with advice on how to remove \nthe surface mount IC.  I applied heat from the blow side of my solder \nstation and it popped off after a little bit with a little help at one \ncorner.  I had lifted all 22 leads from their pads first so I wouldn't \ndamage a pad when it popped off.  There were four small round glue spots \ndown the middle of the bottom of the IC.  Pads 1 and 22 were oversize so \nit was easy to spot the replacement IC with a good blob of solder on \nthose two pads before I started soldering down the other pins.\n\nThanks again for all the suggestions.\n\n-- \nRoy -- W0SL\n",
    "attachments": []
}