Email Detail
Show an email
GET /hyperkitty/api/list/[email protected]/email/WIQHWOM5YZ4URNPTS24I3AK7ERG2HCLW/
{ "url": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/WIQHWOM5YZ4URNPTS24I3AK7ERG2HCLW/", "mailinglist": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/", "message_id": "[email protected]", "message_id_hash": "WIQHWOM5YZ4URNPTS24I3AK7ERG2HCLW", "thread": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/thread/AMAQRI5GKDPRC44SWWBORWSQKIP7SODK/", "sender": { "address": "red (a) redwilloughby.com", "mailman_id": "9091480b0f0242c6abfaf7ea45dbf3e1", "emails": "https://mailman.amsat.org/hyperkitty/api/sender/9091480b0f0242c6abfaf7ea45dbf3e1/emails/" }, "sender_name": "Red Willoughby", "subject": "Re: [amsat-bb] PSAT PSK31 experimental software", "date": "2015-07-17T21:20:42Z", "parent": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/MGANALEKBGMZT5AO6FALUKFTM5JKQV22/", "children": [ "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/Y2HZ5N35VWXJ2MEILTEXDCDR5UPPYSIW/" ], "votes": { "likes": 0, "dislikes": 0, "status": "neutral" }, "content": "Thanks Dave. I will increase power until I start to see my trace. I was \njust following Bob's advice to limit power to 25 watts.\n\nRelative to the SatPC32/HRD SatTrack AOS time discrepancy, which one do \nyou consider most accurate? It makes a difference. I am using an Arrow \nantenna on a G5500 rotator for the UHF downlink. If you are just 8 \nminutes off, the Arrow is pointing about 90 degrees off. I have \nconsidered turning off the automated antenna steering and point it \nmanually with the buttons on the front of the rotator controller. But \nyou must know which prediction is correct or you will be pointing the \nantenna all over the place trying to find where the signal is strongest.\n\nAlso, are the BRICSAT TLEs now giving us accurate AOS times or is the \nsatellite still several minutes behind where the TLEs say it should be?\n\nThanks,\n\nRed\nKC4LE\n\n", "attachments": [] }