Email Detail

HTTP 200 OK
Allow: GET, HEAD, OPTIONS
Content-Type: application/json
Vary: Accept

{
    "url": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/WYKZQ4JZ5H7YIERSSMNKS3MBSLN277V6/?format=api",
    "mailinglist": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/?format=api",
    "message_id": "[email protected]",
    "message_id_hash": "WYKZQ4JZ5H7YIERSSMNKS3MBSLN277V6",
    "thread": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/thread/NDGS6VCH4XCKUQAEQD26BTGKKIYMKOCZ/?format=api",
    "sender": {
        "address": "david (a) rushtone.com",
        "mailman_id": "7a8523604ccc4876b2c68bdf8e304dbb",
        "emails": "https://mailman.amsat.org/hyperkitty/api/sender/7a8523604ccc4876b2c68bdf8e304dbb/emails/?format=api"
    },
    "sender_name": "David Rush",
    "subject": "Re: [amsat-bb] help with WRAPS (XBee version)",
    "date": "2018-05-20T14:39:50Z",
    "parent": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/NDGS6VCH4XCKUQAEQD26BTGKKIYMKOCZ/?format=api",
    "children": [
        "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/WZOX6L4MSSKZKF73LW6YCBXYCUSIKYIB/?format=api"
    ],
    "votes": {
        "likes": 0,
        "dislikes": 0,
        "status": "neutral"
    },
    "content": "Ron:\n\nThe XBee modules need to be programmed in order to work together.\n\nHopefully you have a USB board that you can plug an XBee module into, \nand plug into your computer, in order to (1) update the firmware (just a \ngood practice in general) and (2) configure the two of them to work \ntogether.\n\nYou'll need a USB board to connect one of the XBees to your computer to \nuse it for tracking.  Same board for programming them.\n\n73, David, ky7dr\n\n\nOn /20180520/ 10:25, Ron VE8RT wrote:\n>    It might be in the documentation on the CD, being so close to having\n> my WRAPS working I'd rather not mess anything up at this point.  The\n> mechanical construction is done, although I have the box turned on edge\n> so the PC board will mount sideways, I can work with that.  The\n> elevation and azimuth motions are centered up and move quietly and\n> freely (about 22mA each motor operating continuously with no load at\n> 9V).  The XBee modules files have been uploaded, but I haven't taken\n> mounted one on the WRAPS board yet, as I haven't done any further\n> configuration to the modules.  Are there changes that need to be made\n> to the XBee module files before installing them on the WRAPS board?\n> Are there things I should check or look for before final assembly and\n> testing?\n>\n>    Thanks\n>\n>       Ron VE8RT\n>\n\n",
    "attachments": []
}