Email Detail

HTTP 200 OK
Allow: GET, HEAD, OPTIONS
Content-Type: application/json
Vary: Accept

{
    "url": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/email/5Q2UKWJWAPKJEWZECLMJ7WCEZOSJ2274/",
    "mailinglist": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/",
    "message_id": "[email protected]",
    "message_id_hash": "5Q2UKWJWAPKJEWZECLMJ7WCEZOSJ2274",
    "thread": "https://mailman.amsat.org/hyperkitty/api/list/[email protected]/thread/5Q2UKWJWAPKJEWZECLMJ7WCEZOSJ2274/",
    "sender": {
        "address": "wa4cwi (a) bellsouth.net",
        "mailman_id": "4aa6f1e3f4cd4bf4b1492e47285ca527",
        "emails": "https://mailman.amsat.org/hyperkitty/api/sender/4aa6f1e3f4cd4bf4b1492e47285ca527/emails/"
    },
    "sender_name": "Jim McCullers",
    "subject": "[pacsat-dev] Re: 4 RX devices now working!",
    "date": "2024-05-08T01:26:54Z",
    "parent": null,
    "children": [],
    "votes": {
        "likes": 0,
        "dislikes": 0,
        "status": "neutral"
    },
    "content": "\nCONGRATS!\n\nThere is some code in the receiver task RxTask that can be uncommented and\nwill report all four RSSIs on each received packet.\nA bit of overkill but I used it to notice the two non-working AX5043s were\nessentially dead.\n\nI'll repeat your success when the regulator chip arrives.\n\nJim\n\nWA4CWI\n\n\n\nAll,\n\nI now have all four of the receivers working!\n\nThe two in the center of the board did not have their inputs referenced to\nground. Jim point this out and said he read that they needed to be ground\nreferenced. So I placed a 100 nH inductor on all four of these input and\nconnected it to Ground. I was carefully trying to keep the line length all\nbalanced. \n\nWhen I tested the board all four were working. I have been moving the\nfrequency around on each receiver. I found when two or more receivers are on\nthe same frequency the satellite will respond to a request 2 or more times.\nWhen on individual frequencies then only one reply.\n\nI currently have the four at 145.840  .850  .860  .870 and they are all\nworking indipendently.  If I move the one at .870 up to .875 it stopes\nworking.\n\nI tried to look at RSSI but i think I need to have data coming in when\nreading the RSSI value. I am going to look at this more later and capture\nall the register values.\n\nBob\n\n\n-----------------------------------------------------------\n\npacsat-dev mailing list -- [email protected] View archives of this\nmailing list at\nhttps://mailman.amsat.org/hyperkitty/list/[email protected]\nTo unsubscribe send an email to [email protected] Manage all of\nyour AMSAT-NA mailing list preferences at https://mailman.amsat.org\n\n",
    "attachments": []
}