Thank you for this. Yes, that was going to be the general plan. I am looking through my junk box to see what parts I have and if I have the needed hardware. I was not aware that a USB to Serial converter derived the extra pins (per your earlier post) like DTR and RTS from the USB inputs of Vcc, GND, D+ and D- and made them functional. I assumed it only provided TXD and RXD at RS-232 levels. So, if it makes those pins available and functional, that should do it. I just need to construct and test which might take a couple of days for me to accomplish. Thanks again.
Hi Tim, a problem with that configuration: you need access to the pins Ground and DTR (pins 5 and 4) of the serial port to steer the buffer interface. To steer your Yaesu radio via the Radio 2 COM port you will use a USB-to-Serial converter + a Yaesu CAT cable, e.g. the CT-62. This cable comes with a DB-9 connector on one side that connects to the converter and a mini DIN plug on the other side, that connects to the radio. So, you don't have direct access to the lines Ground and DTR. What you could do: Solder a short cable with a female DB-9 connector on one side and a male one on the other side. Connect the female side to the USB-to-Serial converter and the male side to the DB-9 connetotr of the CT-62. With that cable you can then easily lead out 2 extra wires to the Ground and DTR pins to control the interface.
73s, Erich, DK1TB
Am 01.06.2019 um 14:48 schrieb Tim Rife via AMSAT-BB:
Thanks for the reply Erich. I will give that configuration a try.
Hi Tim, I have described the feature on my website www.dk1tb.de http://www.dk1tb.de http://www.dk1tb.de http://www.dk1tb.de , Engl. page 'Downloads', sect. 5g (Buffer Interfaces). You don't need a PC with a phyical COM port. The voltage at the DTR pin of my USB-to-Serial converter (which generates the Radio 2 COM port) changes between +6 (high) and -6 V (low), when the user switches between v/u and u/v satellites. The corresponding option in menu 'Options' must be checked, of course.
If the DTR pin is low, the buffer interface locks and the relay remains open. If the pin is 'high', the interface is routed and the relay closes. I do not have a transfer relay, but have successfully tested the function with a 12 volt coax relay.
73s, Erich, DK1TB
_______________________________________________ Sent via [email protected] mailto:[email protected] . AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: https://www.amsat.org/mailman/listinfo/amsat-bb