Nice recording and information, TKS ! for sharing.
As an alternative, http://amsat.org.ar/pass.exe concurrent with HDSDR could automatic handle & control Doppler on any generic SDR for RS-44 or any other sat.
73, lu7abf, Pedro
,On 8/12/20, Zach Metzinger via AMSAT-BB amsat-bb@amsat.org wrote:
On 08/11/20 21:47, Zach Metzinger via AMSAT-BB wrote:
Success! The SAW filter eliminated the offending cell-tower sources. The noise floor barely moves when the preamp is switched in, while the desired beacon signal increases significantly.
The 3-D printed passive Lindenblad + homebrew LNA, driving 75' of look-alike-LMR400 is working well for receiving RS-44 now. The LMR400 is optional, as there is plenty of gain from the MAX2640 LNA, but was used to keep losses down when transmitting on this antenna.
I can reliably copy the RS-44 beacon about 8 degrees above the horizon, and SSB is quite readable at about 20 degrees.
A horizon-to-horizon pass recording is located here:
http://www.n0zgo.net/oscar/rs44_12082020_1802.mp3
(The good stuff starts at about 7 minutes into the recording. I chase the beacon at the end in CW mode, and it disappears at 5 degrees elevation.)
A FT-847 was used for reception, but a cheap SDR dongle would probably work just as well for a lost-cost entry into 70cm downlink capability (as required for the GOLF satellites).
Now to wire it up for automatic Doppler correction and we're in business.
73,
--- Zach N0ZGO _______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: https://www.amsat.org/mailman/listinfo/amsat-bb