On 2/23/12 8:29 AM, WA6FWF wrote:
Hi David, As you found out shaded pole motors do not pull more current when they stall, they actually pull less and so they wont blow the fuse, they just sit and cook.
Are you sure these are shaded-pole motors? They're designed for a single-phase supply and are not normally reversible. Nor do they provide much starting torque, which you need in a rotor. They're common in small appliances, especially fans.
The motors in these Kenpro/Yaesu rotors are 2-phase (presumably quadrature), reversible, capacitor-run, AC induction motors. You control direction by applying 24V AC directly to one stator winding and to the other through a phase shift capacitor. In the older Kenpro design that I have, the capacitor is in the control box. In the newer Yaesu models, it's in the rotor. I'm not sure but I think this may have been to provide limit switches to protect the motor.
The running capacitor advances the phase of the current in the second stator winding to establish the rotating magnetic field that drags the rotor in the desired direction. The phase shift isn't quite 90 degrees, nor are the two phase currents the same, so the motor doesn't run as efficiently as it would on an ideal 2-phase supply. Like most induction motors it should draw quite a bit of current when stalled so Dave's fuses were probably just too large.
I'm working on a variable frequency, variable voltage drive for these rotors that changes the frequency and voltage together to vary speed. The main thing I'm after is the ability to run the rotor continuously at whatever speed is required to avoid constant starts and stops that stress the motors, shake the antenna hardware loose, and increase the average pointing error.
The torque curve of a classic induction motor has zero torque at synchronous speed, increasing as the rotor slips under load below synchronous speed and eventually reaching a breakaway peak. When this happens with most loads, the result is a motor stall. Lowering the drive frequency reduces the breakaway speed and increasing stall torque, so starting at low frequency will greatly increase starting torque at the same time greatly lowering the motor drive current.
These variable frequency/variable voltage AC motor drives have long been common in industry, and they've become the standard in hybrid and newer electric cars. Only a few cars like the Tesla actually use induction motors; most now use permanent magnet rotors but the principles are much the same except that a permanent magnet motor has no slip. This would make it easier to keep track of position in an antenna rotor, but there's still the potentiometer, assuming it's calibrated.
--Phil