I had a similar issue when I first started downloading SSTV, and if I recall correctly I believe it was because I had the input audio set way too high (I cranked it down to just about no audio to get a clear pic). If you have downloaded pictures before from HF and have had success at your preset audio levels, then I doubt that is the issue.
Zack KD8KSN
From: kp hpjr Sent: Friday, December 30, 2011 2:41 PM To: zack.kd8ksn@hotmail.com ; amsat-bb@amsat.org Subject: RE: [amsat-bb] Re: MMSSTV and ARRISat-1
Zack and others.
Yes, audio feed is direct as with all digi modes I operate.
Just had a pass of ARRISat-1 of 45 degrees plus over head. The downlink into my M2 5 element yagi @ 35 degrees elevation was S-9 plus 10db. A very good (great) signal.
2 times during the pass the SSTV was transmitted. During neither of them did the program initialize and copy anything. Partway through the 2nd transmission I forced it into RX Robot-36. All that occured was for it to stop after about 5 seconds. Again nothing decoded....frustrating to say the least. I'd like to get 1 photo...HI.
Using the exact same setting I have had several QSO's now on HF sending and receiving very clear photos.
Not sure what else to try.
N0KK, Kirk
From: zack.kd8ksn@hotmail.com To: inservice2him@hotmail.com; amsat-bb@amsat.org Date: Fri, 30 Dec 2011 07:48:57 -0500 Subject: [amsat-bb] Re: MMSSTV and ARRISat-1
Hi Kirk,
Like Greg said, ARRISat-1 is Robot 36. I also found that I received the clearest pictures when I ran the audio directly into the pc versus letting it pickup the audio from a speaker. I imagine you are probably already doing this.
73!
Zack KD8KSN
-----Original Message----- From: kp hpjr Sent: Wednesday, December 28, 2011 4:35 PM To: amsat-bb@amsat.org Subject: [amsat-bb] MMSSTV and ARRISat-1
GA, All the talk about SSTV from this bird got me thinking I'd like to try! I downloaded MMSSTV and installed. What are the best settings to use in the setup page for decent copy of photos from ARRISAT-1? I did copy pix on 14.230 after setup as a test run...but on last pass of ARRISAT, had wonderful copy of voice beacon but no pictures decoded. So wonder what I might be doing wrong. Any help appreciated. Kirk, N0KK
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb