Disregard, went online and the manual at Yaesu online is different than the manual they sent me with the new rotor. Go figure.
73...bruce
On 6/9/2019 12:37 PM, Bruce via AMSAT-BB wrote:
I was just getting ready to solder up the G5500 external control cable. In the manual they provide a diagram of a 7-pin connector. However, the back of the controller is an 8-pin connector and Yaesu provided an 8-pin connector with the unit. Where can I get the information on the 8-pin wiring if it is not in the manual that was provided?
An 8-pin connector would be numbered around the pin with the last number for the center pin. A 7-pin connector is numbered starting at the top, left to right for each row.
This will connect to the LVB tracker which is labeled and easy to connect to.
73...bruce