Take a look at Ebay. Seems to be lots of parts for sale right now.
73 Stefan, VE4NSA
On Sat, Feb 3, 2018 at 6:58 PM, Ron VE8RT ve8rt@yknwt.ca wrote:
I was given a FT726R with the 6 2 and 70cm modules, the maintenance manual, and a few spares. As I was adding a CTCSS tone board it seemed like a good idea to check the adjustments and alignment. Unfortunately I've found that the TX balanced modulator doesn't balance. Checks were made for noise on the 13.8 VDC and regulated 8V (which powers the uPC1037H modulator) and these lines are quiet. The maximum carrier suppresion I could get from adjusting VR05 was 25dB, far short of the specified >40 dB. There is a good voltage swing on VR05, but the voltage on pin 6 of the modulator changes very little. I suspect it's failed.
Can replacement uPC1037H's be found.
If I get this sorted then I'll ask about how to run it duplex and do the Doppler correction on SSB or CW.
Thanks,
Ron VE8RT-- Ron VE8RT ve8rt@yknwt.ca _______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb