Hello Bob Never had that problem But a quick look at the circuit,and if the az is working.Sounds like a bad wire ,or contact if there is a plug on it Check to make sure the wire on terminal#6 is ok Good Luck Howard
----- Original Message ----- From: "Bobby Lacey" amsat@duaneallman.net To: AMSAT-BB@amsat.org Sent: Tuesday, July 28, 2009 3:52 PM Subject: [amsat-bb] G-5400B Rotor / Elevation not working
I have a Yaesu G-5400B and the elevation side of the control box seems to have stopped working. The actual elevation rotor has also stopped responding as well. I hooked up a working elevation rotor to test and didn't get any response out of it. Has anyone experienced this or know of something I should look before before I start tracing the schematic?
Please respond to me directly unless the list thinks this question warrants it's own thread.
73 Bobby KF4GTA _______________________________________________ Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb