Hi Burns,
My 2 cents -- sounds like things are mostly okay (your recieving setup is obviously good if you can hear others in the transponder passband). The big factor that I can see is lack of gain on the uplink. I've successfully gotten into ARISSAT with my 5W QRP radio, but that's using a 13 dBd gain yagi. In theory the ERP of your 25W uplink isn't too far below that, so it would be worthwhile trying the 50W to see if that helps. That or switch to an antenna outside with some gain...
Other factors to consider are sometimes the sats transponder is off (so even if everything at your end is okay you won't hear your own signal, nor anyone elses). And the return signal varies greatly from pass to pass, depending (I think) on the relative orientation of the antenna stub.
Also be sure to try finding yourself on CW first .... SSB is often very difficult to copy on ARISSAT, much easier to start with CW and once you've found yourself switch over.
73! de Dave KB5WIA
Can someone comment on my method, both in terms of technical goodness and good operating practice? A couple specific questions: 1) Xmitting in the middle of the passband and just scanning, I should be able to at least briefly find myself without messing with doppler, right? I was planning to lock the receive and transmit frequencies (constant sum) once I found myself and follow the doppler by hand, but I never got to that step. 2) I'm right that the sidebands are inverted from receive to xmit, right? I think I would hear something even if that was wrong. 3) Finally, what about power? How much have you required for success on ARRISAT? I was running around 25W. I could boost up to as high as 50, but I can only diddle so many knobs in 5 or 10 minutes :-) 3) I know a beam would be better, but trying to reduce variables, and pointing is one of them. Besides, I'm inside in my shack! But has anyone successfully uplinked with an omni/circular? I can always remove the parasitic elements and end up with a center-fed dipole to remove the circularity. (Not sure how that would affect the impedance match...)
Thanks!
Burns, W2BFJ