Tom, I tested that with the FCDP+ as Radio 1 and the FT-847 as Radio 2. I added an additional line for FO-29 to Doppler.SQF with reverse SSB modes (downlink LSB, uplink USB). When I switched between the data lines (menu CAT) the modes changed in HDSDR and at the FT-847. Settings: Radio 1: Kenwood, TS-2000, baudrate 57600, same baudrate in HDSDR, CAT delay 50. Radio 2: Yaesu FT-847, baudrate 57600 All options in menu Radio Setup unchecked.
73s, Erich, DK1TB
Am 13.07.2017 um 06:28 schrieb Tom Schuessler:
All,
A quick question on using SatPC32 to control HDSDR. I have a FCDP+ and can control it via CAT via virtual Serial Port Emulator software. I seem to have some success using the Kenwood TS 2000 settings for Rig for this software/device. Problem is that when I select a Doppler.SQF line in the CAT dialog, HDSDR changes to the wrong SSB mode. I have to manually change it to USB on HDSDR. FM works fine, but SSB modes start out wrong. Is there a better radio emulation to use than the TS 2000?
Also, If I want to use the HDSDR/FCDP+ as the RX and my FT847 as TX, which radio should best be radio 1 and which should be 2?
Thanks much.
Tom Schuessler N5HYP
Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb