Sure Stefan, et al, I'd be happy to share the STL file. I used FreeCAD and will make those files available as well. I'm sure others can further improve the design.
I printed this part out of eSun PLA+, but a better choice for outside use might be PETG.
Regards,
Curt / K7ZOO Tucson AZ
On Tue, Sep 22, 2020 at 6:07 PM Stefan Wagener wageners@gmail.com wrote:
Very nice! Will you make the STL file available?
73 Stefan, VE4SW
On Tue, Sep 22, 2020 at 7:46 PM Curt Laumann via AMSAT-BB < amsat-bb@amsat.org> wrote:
Hi All,
Over the past few months I've been designing & assembling a few 70 cm Lindenblads. The current version is shown in the attached picture (link below). Arrow shafts are used for parasitic elements. The shafts are bonded in place with fiberglass resin. Rubber end caps (from McMaster) cover the shaft ends.
The notable part of this design is the central structure (supporting parasitic elements) is 3D printed as *one part*. Virtually all of the angles and spacings are achieved in the 3D printing process. After struggling to align and bond various PVC and irrigation parts in other versions, it was a breeze to assemble this design: one nylon machine screw, one nut, four bonding points.
The design could be easily modified to accommodate 0.125 inch diameter parasitic elements as well.
Regards,
Curt / K7ZOO Tucson AZ
https://drive.google.com/file/d/1i2c6T5lZtI00KChbJuyphvvechzBvlNw/view?usp=s... _______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: https://www.amsat.org/mailman/listinfo/amsat-bb