Jordan / rich
I just received my TM-D700A also & followed your cable instructions. When I powered up my 700A I get the following data; TASCO Radio Modem AX.25 Level 2 Version 2.0 Release 03/Dec/99 3Chip ver 1.08 Checksum $04 cmd:DA 070327210135 cmd:
Trouble is now it won't accept data when I try to type in the commands. Have you guys been successful in inputting data from the keyboard.
73 Bruce KG4YEV
----- Original Message ----- From: n3wwn@futuretek.cx To: "Jordan Woolley" jordanw@unwired.com.au Cc: amsat-bb@amsat.org Sent: Tuesday, March 27, 2007 12:26 PM Subject: [amsat-bb] Re: TNC settings for Kenwood TM-D700
Hi Jordan!
Make sure you're using a straight through serial cable (2-2, 3-3, etc).
Then, confirm that the PC and D700 are using the same parameters: 9600 baud, No parity, 8 data bits, 1 stop bit and hardware flow control. If your settings aren't the same as this, make sure both the PC and D700 agree.
From non-TNC operations, press and hold F for 1 sec and then press the
TNC soft button. Do this twice. The D700 display should have TNC PKT in the upper left.
If the display shows TNC APRS, you just have to press and hold F for 1 sec and TNC once.
Hit CTRL-C to return to a cmd prompt if you're stuck in converse mode (you shouldn't be since you just put the D700 into TNC PKT mode).
At this point, you should be communicating with the D700 at the cmd prompt.
Check out the Kenwood Specialized Communications Manual:
http://inform2.kenwoodusa.com/Manuals%5CTM-D700A%20Specialized.pdf
Good luck!
73 de Rich N3WWN (FN00fh)
On Tue, 27 Mar 2007, Jordan Woolley wrote:
Hi all,
Was just wondering if there is anyone out there with any experience setting up a D700 for Packet operation. I do not seem to be able to get my terminal program to speak to the TNC. I can't even get a cmd prompt or any semblance of a connection. It seems to be physically connected fine but still no luck. I have set the baud rate for the port to match the TNC (9600) but am not having any luck. I am just using HyperTerminal. Any ideas?
Thanks Jordan
VK2HCA _______________________________________________ Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb