There is software available for the RaspberryPi which will let you extend USB as far as you can run Ethernet. One USB port is free, more than that requires a license.
I have not tested it yet, but will use it to put a FCD connected to omni antennas on my tower as a monitor receiver. The tower is 350' from the house.
73, Jim wb4gcs@amsat.org
On 2/11/2015 11:50 PM, Pavel Milanes Costa wrote:
On the subject of using ethernet UTP CAT 5/6 cable for making USB extenders...
I have a kind if experience on that, you can reach about 15-20m runs easily without losing connection to the usb dongle (even wifi dongles)
If you want to go for sure, don't use more than 12m... from there on is a challenge, I use on daily basis a run of 14m switching from RTL-SDR and a WIFI dongle, as always your mileage may vary.
The better way to cable the extender with UTP CAT 5/6 is this (my experience):
The UTP5/6 has 4 pairs of cable:
- Use one pair (two wires) for the GND
- Use one pair (two wires) for the +5V
- Use one pair for the data transfer, one wire for D+ and the other
for D-
If your dongle get disconnected or errant behavior use the free pair to add one more wire to each GND and +5 volts lines. (more wires in parallel = less resistance = less voltage drop)
Put a little ferrite core (1 cm OD, 3mm H) at each end of the cable (just a pass trough) plus a 10nF and 10uF at the far end from the computer between the GND and +5V (10uF is electrolytic, watch out the polarity)
The ferrite will protect you a little from a nearby TX station (full duplex?)
With this setup I can run a wifi dongle at runs from 12, and some times I put the RTL-SDR there too...
Don't be tempted to put more uF on the far end 10uF is good, you can kill your USB port by putting something in the order of 3300 uF or more (Been there, done that, got my USB port killed)
Don't use this extension cable on accessory USB ports, use only the rear ports of your motherboard.
You will lose some bandwidth, My RTL dongle runs easily 2.8 Mhz on the PC and on the far end of the extension it only reach about 2.2 Mhz
Things to note:
- UTP cat 6 is better
- Shielded UTP is even better, the shield must be connected only on
the PC side and not to the USB GND line, but to the PC chassis.
- if not shielded cable, you may get a USB reset if you TX on HF with
high power, but 2m 50W don't seem to harm on my case (if you forgot the ferrites you will be killed by 2m TX too)
I hope this can help, 73 from CO7WT.
El 11/02/15 a las 21:41, Stephan Greene escribió:
This approach would work well, I think for portable ops, too. Maybe without extenders, just a long USB cable. I think USB 2.0 is rated to 10-15 ft without boosting the signal.
Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
--- This email has been checked for viruses by Avast antivirus software. http://www.avast.com