Mike,
Is there a reason you want to use two FT-847s instead of just one?
73,
Paul, N8HM
On Wed, Jun 5, 2019 at 4:34 PM Michael Wolthuis via AMSAT-BB amsat-bb@amsat.org wrote:
Ok, so I am fairly new to SatPC32 since leaving my old setups....
I have dual FT-847's setup as follows:
FT-847 - TX/RX UHF, RX 2.4ghz (down convert to VHF) FT-847 - TX/RX 2m
So, I setup SatPC32 for two radios. Both radios are being controlled.
Issue is it is fine for V/U, but then on a U/V SAT it has the frequencies flip-flopped.
In other words, I think it always uses RADIO A for uplink and RADIO B for downlink?
Is there a way to change/fix this behavior? I want U on the UHF radio and V on the VHF radio.
Mike kb8zgl _______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: https://www.amsat.org/mailman/listinfo/amsat-bb