My FD interfaces SatPC32 with a Yaesu G5500DC. I am using SAEBRTrackBox as the SatPC32 setting. SatPC32 is running on a W11 laptop. To interface with FD required installation of a CH340 driver for the com port to FD. 

HyperTerminal wasn’t necessary for FD installation. I didn’t have it and found that getting it and using it was more complicated than manually following the prompts from FD.

GL and 73,

Ray KN2K 


Sent from the all new AOL app for iOS

On Thursday, July 27, 2023, 1:14 PM, Vince Fiscus, KB7ADL via AMSAT-BB <amsat-bb@amsat.org> wrote:

Hi again,

I just ordered a Fox Delta controller which should get
here in a couple weeks. Right now I'm studying configuration
for use with Satpc32.

In one place I'm seeing is use Yaesu GS-232 in Satpc32 for the  Fox-Delta
controller, in another place I'm seeing use SAEBRTrackBox in Satpc32 for the
controller.

Not sure which to choose. Any suggestions?

I'd also like to get the list of LVB tracker controller commands
for use in HyperTerm.  Fox-Delta uses the same firmware, but I
can't find the command list.

Thanks
KB7ADL


-----------------------------------------------------------

Sent via AMSAT-BB(a)amsat.org. AMSAT-NA makes this open forum available
to all interested persons worldwide without requiring membership. Opinions expressed
are solely those of the author, and do not reflect the official views of AMSAT-NA.
Acceptable Use and Privacy Policies available at https://www.amsat.org/about-amsat/

View archives of this mailing list at
https://mailman.amsat.org/hyperkitty/list/amsat-bb@amsat.org
To unsubscribe send an email to amsat-bb-leave(a)amsat.org
Manage all of your AMSAT-NA mailing list preferences at https://mailman.amsat.org