Bob,
Open the CAT option on the top bar. Inside you will find to adjustment girds, one of RX and one for TX. I think that will accomplish what you are trying to do. On my IC-901H is use the RIT control which is good for samll cahnges. If more than that I just retune my VFO to their frequency.
John
On Fri, Feb 15, 2019 at 2:41 PM Bob WB4SON@gmail.com wrote:
Hi,
I'm using an Icom IC-9100 and the RIT control is almost useless as it changes frequency very slowly. To change 1 KHz takes about 15 seconds, a lifetime on a pass. In other words if a station calls me and they are a KHz off, then they will be off the air before I can get the RIT set.
I'm running SatPC32 v 12.8d. The manual implies that there are Downlink adjustments when the V+ mode is turned on, but I only see uplink adjustments to the right of the frequency display that can either be moused up/down, or respond to the +/- keys.
Perhaps there is something else that would open Downlink adjustment to the left of the display? Or maybe other keys that adjust the Downlink?
73, Bob, WB4SON _______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb