John:
I have maximum elevation set to 180 degrees but I did not see a separate box to enable “flip” mode in the configuration. And I do not recall the box behind the “R” turning yellow.
Thanks
Bob AA6TB
From: John Kludt [mailto:johnnykludt@gmail.com] Sent: Friday, August 31, 2018 5:53 AM To: Robert Koepke Cc: Amsat BB Subject: Re: [amsat-bb] Yaesu G5500 Rotator Issue
Robert,
Do you have flip mode enabled in SATpc32? If it is the background behind the "R" will turn yellow. If you started the pass in the middle, maybe things got a little confused.
John
On Fri, Aug 31, 2018 at 8:42 AM Robert Koepke rkoepke@socal.rr.com wrote:
I am using SATPC32 V12.8c with a Yaesu G5500 rotator and a GS-232B controller. In rotor setup the Max elevation is set to 180 degrees. The rotator has not been calibrated in some time, but it seems to be pointing in the correct direction and has been working properly.
But on an overhead pass (>65 degrees) when I turned on the rotor control in SATPC32 the antenna went to the horizon at the proper azimuth but flipped so the control box showed elevation at 180 degrees (visually verified). Tracking was correct but when the antenna was back down to about 45 degrees the antenna swung around 180 degrees and "unflipped" the antenna, then tracked properly to the opposite horizon. Since then it has been working properly again, but I have not had another overhead pass.
Has anyone seen this type of behavior or can direct me to a possible remedy?
Thanks Bob - AA6TB
_______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb