Sure can, I've done it before switching to the twin radios. If you only configure one radio with SatPC32, it uses the "SPLIT" fuction of the FT8x7 to automatically set both the RX and TX frequencies for doppler on VFOs A & B.
Remember that a critical factor for operating on the linear birds is calibrating your particular radio for the uplink / downlink offset. This is really easy with two radios (since you can hear your own downlink) but with a single radio it's much more difficult. Out of the box, my twin FT-817's were about 2 kHz off with the default frequency offsets in SatPC32. Before ARISSat, try practicing on VO-52 or AO-7 with their 70cm uplinks and 2m downlinks -- they're often not crowded at all, and it will be good to get your rig close in calibration with the help of some others on the air there.
73 de Dave KB5WIA / CM88
On Thu, Feb 10, 2011 at 11:33 AM, Ron Overdrive ronoverdrive@tehfurry.com wrote:
Question I have is, is it possible to use SatPC32 to control 1 FT-817 either in split frequency or in each VFO (ie switching between VFO A & B) with the Doppler shift corrections? At this time my FT-817 is my only 2m/70cm rig that supports SSB and I would like to be able to operate on the linear birds especial ARISSat-1 when its launched. I'm fully aware I would not be able to hear myself in the preferred full duplex operation, but something is better then nothing until I can acquire another SSB rig either in 2m or 70cm.
~73, AC2RF Ron