Ed:
If you use a Comet Diplexer such as the CF160 that I have, it can split things out to two antennas and then you can use a preamp on the receive side. I have used that approach when I have worked sats low to the horizon or when I had time to find a good parked position with a clear view of the sky.
Ron KA4KYI
Edward Cole wrote:
Jeff,
You are partly correct, but the main job of the preamp is to lower the noise figure of the overall receiving system. The gain in the preamp is primarly to provide a strong enough signal for the following receiver that its noise figure is not significant. Having enough gain is important so that there is enough extra too overcome coax line loss and still have sufficient gain left over at the receiver (approx. 15-dB is needed).
So, a preamp can help a mobile satellite station if there is a way to install it. If your radio only has one antenna connector for both 2m and 70cm, then it will not be possible to use a preamp for a full duplex radio. If it is not able to operate duplex then a switching preamp would work OK.
73 Ed - KL7UW
At 09:52 AM 3/31/2008, Jeff Mock wrote:
It's not clear that a preamp will improve your reception. The 2720H has a pretty sensitive receiver. The preamp will help you if the noise figure of the preamp is better than the noise figure of your radio. It's not clear to me that you can make much of an improvement here.
I have a preamp on the masthead at home, but I have a long feedline from my receiver to the antenna, I have about 7db of loss from the antenna to the radio at 70cm and I get a noticeable improvement with a preamp. The main job of my preamp is to overcome the loss of the feedline, otherwise the preamp is not that much better than the radio.
jeff AD6EO
Kent R. Frazier wrote:
Hi all,
I am really enjoying the satellite aspect of the hobby and have enjoyed the contacts I have made with my Icom IC-2720H with a 19" whip antenna from my vehicle. I have seen talk recently of using a preamp to improve the reception. From what I've read and understand, it appears that a
"switching"
preamp is needed for a setup using only one antenna for Tx and Rx such as mine. Is this correct?
It also appears that most of the preamps are mast mounted. Since this would not be an option for me can the preamp be put near the transceiver? Are there any issues that result of doing so?
Lastly, what preamp(s) would you recommend for an application such as mine?
Thanks,
Kent
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb