Last winter I temporarily set up a 2m 1/4 WL ground plane with 432 preamp (similar to the ARR) and powered it with a single 9v "transistor" battery. Most of the Gasfets use regulators to lower 12v to a usable working voltage. Or for a long-term solution series two 9v batteries and add a LM7812 regulator. Simplest wx-tight enclosure for an ARR preamp is a small zip-lock bag. All small enough for hand-held Arrow setup.
73, Ed - KL7UW BTW interested if Kenwood will come out with an upgrade for the TH7-G (had one and was great little radio)
At 04:01 AM 10/21/2009, Bruce Robertson wrote:
I'm grateful to everyone who has contributed to this discussion.
It strikes me that the greatest improvement we could make to hand-held yagis would be to somehow integrate a low noise preamp circuit very close to the 70cm port. I have an indoor-style ARR preamp that I've thought of connecting to the boom with cable ties. A powersupply using AA batteries and a DC to DC buck-boost chip from, e.g., Maxim, would keep the whole thing light. (Alternatively, I see that the max voltage for my ARR is pretty high: I might get away with a pair of Nicad '9v' batteries.)
Like so much of amateur radio, it's more of a challenge of construction than anything else.
Has anyone experimented with this sort of improvement?
73, VE9QRP Bruce
On Wed, Oct 21, 2009 at 8:21 AM, Allan Saul allan@rfdesign.co.za wrote:
Quite a lot of guys are using the handy Arrow Model 10W duplexer for the handheld 146/437 antenna and mine arrived here today so I thought I would put it on the network analyser and see how it performs.....
From the Radio cable to the 2m antenna connector an Insertion Loss of
0.75dB was measured with a rejection of 57dB at 70cm. The VSWR at 2m was 1.24:1
From the Radio cable to the 70cm antenna connector an Insertion Loss of
1.2dB was measured with an attenuation of 56dB on the 2m signal. The VSWR at 70cm was 1.29:1
The VSWR on the 2m port was 1.21:1 and on the 70cm port was 1.20:1
For those guys wanting to look at the actual plots they can be found here
http://www.rfdesign.co.za/default.asp?pageID=785423593&filePath=D:%5CSof...
73's Allan ZS1LS
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb
73, Ed - KL7UW, WD2XSH/45 ====================================== BP40IQ 500 KHz - 10-GHz www.kl7uw.com 500-KHz/CW, 144-MHz EME, 1296-MHz EME DUBUS Magazine USA Rep dubususa@hotmail.com ======================================