Jan,
I had a similar experience. I was able to get in, but not as well as others. This morning, I put a calibrated service monitor on the rig. The PL signal looked clean, and was at 700 Hz deviation, as specified in the service manual. That is slightly higher than the nominal 15% of normal deviation usually quoted. I don't have a frequency counter of sufficient accuracy to check the PL tone frequency, but it was obviously close and switched properly by the software. I get in to SO-50 and SO-67 with no more trouble than others, as well as the local repeaters with PL access.
Alan WA4SCA
-----Original Message----- From: amsat-bb-bounces@amsat.org [mailto:amsat-bb-bounces@amsat.org] On Behalf Of PE0SAT Sent: 21 December, 2009 13:06 To: amsat-bb@amsat.org Subject: [amsat-bb] Unable to use HO-68 in JO21 (18:37 UTC)
Hi,
I was unable to open the uplink with my Yaesu FT-847. The PL tone was set 67.0 Hz but unable to open the uplink channel.
During the pass I tryed the following.
- Checked Subtone.SQF file twice SatPC32 (XW-1,67.0,$3F,1) - Checked Doppler.SQF (XW-1,435675,145825,FM,FM,NOR,0,0,Repeater-BBS) - Restarted SatPC32 - Switched of and on the Yaesu FT-847 - Did a manual setup via menu option 12 for the tone frequentie - Used FMN on the uplink
Nothing worked :(
There where only three or four stations active during this pass and that makes me wonder if I was the only one with tone problems?
I did receive some BBS Packets:
BJ1SA-12>BBSTAT>UI,C,F0: Open BJ1SA-12:0
BJ1SA-12>BBSTAT>UI,C,F0: Open BJ1SA-12:0
Maybe beter luck next time
73's PE0SAT
_______________________________________________ Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb