My initial investment is minimal
When I assemble the RF switches I must choose a RF range....The range is determined by the choice of a specific resistor. The default three >ranges suggested are 0-10 watts, 10-30 watts, and 30-100 watts.
The answer is actually in what transmitters or power amplifiers are you planning to use that fit within your budget?
Watts cost money...
With a limited gain omnidirectional you might best aim toward the middle range but if you are looking at used SSB/CW equipment at 430, many of the less expensive older radios only ran 10 watts out. Of course a "Linear Amplifier" for SSB/CW could move you up but is not necessarily inexpensive.
You might want to just accept the fact that you may need to "climb the tower" again once you settle on your transmitters.
Roger WA1KAT
Sent: Sunday, October 19, 2008 1:30 AM Subject: [amsat-bb] beginner question re: uplink power
hello,
My initial investment is minimal
When I assemble the RF switches I must choose a RF range....The range is determined by the
choice of a specific resistor. The default three ranges suggested are 0-10 watts, 10-30 watts, and 30-100 watts.