A little bit of heat wont hurt either.
Then instead of oil or grease I use a copper based anti seize compound. works great and keeps the connection good to because of the copper.
The Original Rolling Ball Clock Idle Tyme Idle-Tyme.com http://www.idle-tyme.com
On 6/2/2010 11:31 AM, B J wrote:
<snip>
We are leaving today for Europe and of course I waited until the last minute to take down my Arrow antenna, which has been mounted outside for about a year. But, when I attempted to unscrew the elements, they would not budge, even after receiving a big dose of WD-40. And the elements are not that solid so it's not possible to use a great deal of force.
Is there some trick to unscrewing these things?
<snip>
I've loosened corroded threads after applying penetrating oil and then *gently* applying torque. Usually I was successful, though I sometimes had to repeat the process.
After disassembling the elements, it might be a good idea to remove the threaded stud and run a tap down the holes at the ends of the shafts to clean them out. I also recommend cleaning the external threads with a wire brush or running a die over them.
If the latter doesn't help, replacement studs might be available at places such as hardware or building supply stores or automotive parts dealers. If not, they could be made by cutting ready rod to length and beveling the ends.
To prevent the threads from binding in the future, there are compounds available just for that purpose. A building supply store might have something like that for threaded pipe. Just dip the external thread in it and screw the element back together.
I hope this helps.
73s
Bernhard VA6BMJ @ DO33FL
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb