It may also help if you save the file with the correct name as Doppler.SQF rather than as Doppler.SQX -- Mark D. Johns, KØJM AMSAT Ambassador & News Service Editor Brooklyn Park, MN USA EN35hd ----------------------------------------------- "Heaven goes by favor; if it went by merit, you would stay out and your dog would go in." ---Mark Twain
On Tue, Dec 1, 2020 at 2:09 AM Bill Dzurilla via AMSAT-BB amsat-bb@amsat.org wrote:
I was just advised that, contrary to the RS-44 line in the JE9PEL file, it should be REV rather than NOR. If so, that would explain a lot. 73, Bill NZ5N On Monday, November 30, 2020, 02:10:53 PM EST, Bill Dzurilla billdz.geo@yahoo.com wrote:
Hello, Does anyone have any tips for proper configuration of the Doppler.SQX file on SatPC32? I'm having a hard time getting it correct for RS-44. I started with the standard line from JE9PEL: RS-44 (DOSAAF-85),435640,145965,USB,LSB,NOR,0,0,SSB When I heard the sat, I started clicking the Uplink Calibration buttons in the CAT Control window until my voice sounded natural. It was pretty far off, something like 8800hz. To save, I clicked on Change/Store Data File and then clicked RX/TX Freq. Data. I thought this was all I needed to do, but on the next pass my TX and RX were again out of sync. On every pass, I need to start over, and each time the uplink frequency is several thousand hertz off. My current line is: RS-44 (DOSAAF-85),435631.85,145970.86,USB,LSB,NOR,0,0,SSB What am I doing wrong? Thanks and 73, Bill NZ5N _______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: https://www.amsat.org/mailman/listinfo/amsat-bb