From the manual:
Connect each wire to the terminals on the rear panel of the controller, making sure to match the numbers on the pins......
So, yes, it's 1-1, 2-2, 3-3, etc
Jim
On 04/20/2014 11:30 PM, David Rush wrote:
I've got a used set of Yaesu G-5500 az/el rotors, and the plugs that attach to the rotor housings. I need to build cables to connect them to the Yaesu controller.
Page 3 of the instruction manual shows some info about the wiring, but doesn't explicitly say which screw terminal on the controller goes to which pin on the rotor plugs.
Is it simply 1-1, 2-2, ... 6-6?
David, ky7dr _______________________________________________ Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb