Randy, Make sure you have any audio or DSP filters switched off, IF shift to centre etc. I found the 'tone' control on the FT736 affects the decode (eventually, by accident).. Also I found that I had a dirty contact on the soundcard input to my PC's motherboard! After I fixed some of these things, the decode was okay, mind you I suspect shielded cable would also be better - I'm using twin speaker lead.. :( . Put the CW at the marker (as close as possible and adjust for doppler) in USB mode and you should get some good frames eventually. I've found usually the high elevation passes are reliable, the low ones at 3-5 degrees just don't give me enough of a chance to get telemetry sometimes.
The soundcard is usually part of the issue also. My old P-4 shuttle mainboard AC97 codec style soundcard I think only samples at 48KHz or something and uses software drivers to pretend the sampling is at other rates - a proper PCI soundblaster style card or high quality SDR style soundcard would probably work better. At some stage I might try a better PC but for now it works some of the time straight from the headphone socket to line-in on the soundcard.
73 James VK6FJA
On 30/08/2011 2:00 AM, Mark L. Hammond wrote:
Hi Randy,
Some people have reported that some types of "soundcard interfaces" don't work with this telemetry format. Some reports are even from reliable sources ;)
All kidding aside---where are you getting audio out of the radio; what is the path to the sound card (straight wire? some type of interface, either homebrew or assembled?); and what sound card input are you using?
This is a case of "simple is better."
Mark N8MH
On Mon, Aug 29, 2011 at 1:38 PM, Randyrswart1@twcny.rr.com wrote:
Hi all ..
I am receiving the CW and TLM ok signal wise ..
I tune in the CW to the mark in the CW / BPSK window..
But I don't ever receive any telemetry ..
Using USB, FT897D ..
I use the rig and computer for BPSK31 all the time ..
Any ideas or suggestions ?? I even watched the You tube
Video that was posted ..
It seems like I am doing it correctly .. but must be missing something ..
Thanks..
Randy - N2CUA
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb