Peter,
I had the same problem until I looked back through the general documentation. Was not clear in the 9700 setup instructions.
When you bring up the radio setup it comes up showing "Model" in the top pull down field next to "Radio 1". Select Icom radio button, then you need to click on that pull down field and select the third choice which is "Addresses" it should show "$A2 $A2" in the pull down field just below. If not, you can activate the pulldown and select the correct one or adjust each field using the "up/down" arrows beneath each address that is shown.
Hope that makes sense.
Jack Spitznagel – KD4IZ Trustee for NR3DT The Museum Ship USCGC Taney WHEC-37 Amateur Radio Group
-----Original Message----- From: AMSAT-BB amsat-bb-bounces@amsat.org On Behalf Of Peter via AMSAT-BB Sent: Saturday, May 9, 2020 10:24 To: amsat-bb@amsat.org Subject: [amsat-bb] Satpc32 and ICOM 9700
I'm confused, the address for my radio is A2h but the choices inside Satpc32are nothing like that. What am I missing? Also, how can you confirm the program and radio are communicating? How can I force the program to do something to the radio and thus show me that they arein contact with one another? I've turned on CAT and it goes plus without anerror but that's not enough THanksPeterW2PP _______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: https://www.amsat.org/mailman/listinfo/amsat-bb