Me again, 3.50b is the most current eprom. You must connect it to an external 12 VDC even when in standalone mode.
Finally, the binary switch ( one of my TrakBoxes has a rotary and the other has 2 push buttons for moving up and down the 9 satellites plus "0" for normal mode ) on mine does not automatically switch satellites when you switch between "0" and any satellite. It also does not switch back to "0" terminal mode from any satellite. The first change in switch position requires a reset. So once I have gone to "1" from "0" and do a reset, I can then go to any other satellite with just the switch.
If I then go back to "0" I need to again "reset". An ON/OFF is as good as a "Reset". On the original kit the reset was a momentary ON switch at the back.
I just checked the schematic and parts list from 1993 and the switch is referred to as a 16 position BCD switch.
Hope this helps.
-----Original Message----- From: amsat-bb-bounces@AMSAT.Org [mailto:amsat-bb-bounces@AMSAT.Org] On Behalf Of renauld halbardier Sent: May 5, 2008 5:05 PM To: amsat-bb@AMSAT.Org Subject: [amsat-bb] Trackbox
hello all
my 'old' trackbox (dusty!) ,after 5 years of sleep, doesnt work in stand alone mode anymore ; terminal mode works perfectly. Ram has been cleared , clock adjusted, new keplers loaded ; version is 3.50b.
Any ideas ?
73
renauld on4kvi _______________________________________________ Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb