Honestly...I wonder how many of the operators have keys to send those dits...
Roger WA1KAT
On 1/7/2014 7:59 PM, Ronald G. Parsons wrote:
Perhaps it’s just me, but it seems like an increasing number of operators are trying to find their downlink by speaking into their mic while tuning up and down the band, often plus or minus 20-30 kHz. Not only is this disruptive to existing QSOs, it is not the most effective way to do it. My receiver has a panadapter with a 40 KHz bandwidth, and I can see these SSB signals swishing up and down, over and over.
If you don’t have computer control of your frequency, set up a switch by which you can send a SHORT series of dits. Then don’t swish. Adjust your transmitter is steps of about 3 kHz. Send a burst of dits at low power and listen. If you don’t hear yourself, tune up or down. This way you will have an effective way to find yourself and you won’t interrupt other QSOs repeatedly.
Once you find yourself, make sure you are not interfering with an existing QSO. Then refine your tuning until your frequency is nearly right. If you are operating CW, your done. If you are operating SSB, try holding a tone generator near your mic and adjust your transmitter or receiver until the tone on the downlink matches the tone generator.
There is probably a free tone generator available for your smart phone.
Better yet, try computer control of your transmitter and receiver. You can easily find an Elmer on the air if you need help.
But, PLEASE. don’t swish!
Ron W5RKN _______________________________________________ Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb