Hello Andy et al...I look at it like each of the satellites we use have their own "personalities", AO-73 being new we must learn it's idiosyncrasies. When AO-7 was "reborn" we had to understand and learn how the grand old lady functioned. Now it's "fairly" easy (most of the time). It seems there is always a learning curve in front of me. If there weren't one provided I'd probably create one. Nice to hear the usual culprits on AO-73. 73 Bob W7LRD
----- Original Message ----- From: "Andy Kellner" hawat1@yahoo.com To: amsat-bb@amsat.org Sent: Monday, November 25, 2013 4:46:55 PM Subject: [amsat-bb] Re: AO-73 sometimes hard to access
James,
now, not at all. Nobody is gonna dismiss your problems / concerns. For the people who work SSB satellites, they know that it can be a tricky business to get it right. And if you add to this a more-or-less un-proofen, new satellite it can make it even more tricky.
Now to my observations to last nights 55 degree pass over VK4 (orbit #62, sat eclipsed):
- Linear Transponder was there. I needed to start with an uplink frequency 4.2 kHz. higher than specified. This offset kept increasing thru out the pass to about 5 kHz. at the end of the pass (thats in addition to the doppler correction). - Made a brief contact with a VK3 station which had similar problems finding/keeping its signal. - Once the downlink has been received, the signal was strong at times, however I noticed significant variations in signal strength on the downlink. - I observed the same variations on the telemetry transponder. The signal is nice and strong and easily decodable in one frame and barely audible the next. Almost if the sat switches back and forth between high power / low power ? Other explanation could be the satellite rotating. This effect is certainly there from larger birds such as AO7, but I am not sure if any rotation would make any difference from a tiny cubesat ?
Equipment: Full duplex Yaesu 847, doppler corrected with CAT/SatPC32 and automatic tracking antennas (Nova), mast mount pre-amps etc. 2013-066B keps used.
Andreas - VK4TH
________________________________ From: James Luhn luhn@wt.net To: amsat-bb@amsat.org Sent: Tuesday, 26 November 2013 8:55 AM Subject: [amsat-bb] AO-73 sometimes hard to access
I have had the same experience as Perry with AO-73 with regards to signal problems. I have an IC-910 transceiver and a M2 2mcp14 (2 meters) and M2 436CP30 antenna with a Yaesu G-5500. I have the IC-910 set to about 25 watts on UHF. I have made one contact on AO-73. It has taken me forever to get the doppler correct as I usually cannot hear my signal. Last night my returning signal was extremely strong for about 1 minute. In comparison, the received signal from FO-29 is extremely strong so I am assuming that my UHF antenna is working fine. Like Perry, I have never experienced this before. At times AO-73 takes some very deep fades (telemetry). With such a small little cube, I would not think the satellite is blocking the antenna (although 4 inches is starting to get close to 435 wavelength. The frequency offset confused me at first. I just kept cranking up the frequency and there I was but very, very weak. I'm not gripping as I am having a blast. Those of you with experience are probably getting a laugh at what I report. I am a newbie to this satellite stuff and learning as I go and extremely excited to make even one contact. Maybe the geese overhead are causing me some problems. :-)
73, -james W5AOO ...a ham for 50+ years and enjoying every minute of it! _______________________________________________ Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb _______________________________________________ Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb