The Icom 9100 isn't overpriced at all considering all it does. If all you want to use it for is the satellites, there are cheaper alternatives. However, it also does true dual receive on HF (something the Yaesu FTDX5000 and Icom 7600 don't do), it has the roofing filter options for increased HF/6m performance, plus several other nice features. If you want a good, high performing HF/VHF/UHF rig, it is a great bargain.
73s John AA5JG
On Tue, May 3, 2011 at 1:10 PM, K5OE k5oe@aol.com wrote:
I can tell already this is an old thread that will go on for a while…
Money is almost never “not an issue,” so fitting the radio to the user is always a matter of preferences and priorities. If you want HF + satellite in one rig, the TS-2000 and the FT-847 work, but not the IC-910. If you want 23 cm in the rig, the TS-2000 and the IC-910 work, but not the FT-847. If you want to power your preamp(s) without any external wiring, the FT-847 and IC-910 work, but not the TS-2000. If you want a built-in antenna tuner (HF), or a built-in TNC, or built-in voice recorder, then only the TS-2000 works. If you want lots of 3rd party software, then the FT-847 is your best bet.
I agree with Ed, the IC-9100 seems priced outrageously for what it is—reminiscent of the IC-970H. Maybe I’ve just lost a sense for the market—look at the price of new cars! For a strictly satellite rig, an IC-821H is still a very good radio selling for half the price of a used IC-910 (and just a bit more than a FT-736—the FT-847 of a previous generation).
A decade ago I bought a TS-2000 for a number of reasons, including the ability to work the HF satellites (RS-12/13 and AO-7) in one rig. I sold an FT-990 and an IC-820 and had money left over. I still consider it really good value. While I have never liked the controls as well as my Yaesu HF rig(s), I came to really appreciate the DSP functions and the CW features and had great fun with the TNC on the ISS, pacsats (especially UO-22, RIP), and APRS. I added 1.2 GHz when AO-40 was launched. I scored higher in HF contests with it than I ever had with the non-DSP Yaesu rig. I wasn’t bothered (too much) by the infamous birdie because I could tune around it with the combination of a high-gain UHF antenna and a preamp, but do consider it a fatal flaw to anyone considering the radio for use on AO-27 or SO-50 with a low-gain antenna system.
I’ll end with an echo of Dee’s comment below: spend your time and money on the antennas, as almost any radio will work with a good signal.
73, Jerry, K5OE
--- original message --- Having the FT-847 since early 1998 and observing the IC-910 I would recommend both over the TS-2000 or new IC-9100 on basis of bucks spent. I realize both the 847 and 910 are out of production but good used units are available for <$900.
The TS-2000 "birdie" issue is unforgivable for the money spent (Unless you are not interested in satellites which the FT-857/897 would then be my choice). The IC-9100 is outrageously expensive and would only be a choice if you have no HF equipment. It is still too new for a complete opinion (for what you spend you could have top notch transverters and a new K3*, or buy two FT-817 with amps for a lot less).
*Note: the K3 is not able to do duplex at this time, but I have an idea how it could by using the dual receiver IF. My K3 with DEMI transverter is much superior to the FT-847 on 2m, but that is only for very weak-signal applications (satellites are on the strong side of weak-signal if you get my drift), and use on HF (which is not the question that was asked).
73, Ed - KL7UW
At 06:46 AM 5/3/2011, Dee wrote:
Andrew, Being in this end of the hobby for "many" years, I have learned that sometimes the choice comes down to what you can afford. While the TS2000
is
a nice radio, with the birdie problem, it leaves a question. Ihave had 2 Icom 910's for many years and even have one of them adapted with the
1.2ghz
module. Both have worked flawless and have been more than adequate. The new ICOM 9100 (which you ask about) is a bit pricey for the bands
provided.
I have been following the production of the 9100 and it has become out of
an
average hams price range. While the specs are very good, you can achieve the same effect with a TS2000 - Icom 910- Yaesu 847 and even the older
icom
820 (?) - Once again, I have always advised sat ops to spend the money on the
antennas
and coax as this is where you'll find the most advantage for your
operation.
Good luck and go to the AMSAT website to obtain a truck load of info pertaining to satellite station construction and operating advice. 73, Dee, NB2F NJ AMSAT Coordinator
-----Original Message----- From: amsat-bb-bounces@amsat.org [mailto:amsat-bb-bounces@amsat.org] On Behalf Of Alvaro Gaviria Sent: Monday, May 02, 2011 4:51 PM To: amsat-bb@amsat.org Subject: [amsat-bb] Question about radios
Hello all,
Can someone tell what is better for satellite work, the Kenwood TS-2000X
or
the Icom IC- 9100 ??
Best regards
Andrew HK4MKE
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb