SatPC32 will do your CAT control. It's built in, you just have to set it up.
The pre-amp power supply must have some means of sequencing with the PTT of the radio. Check the instructions and the transceiver manual.
Looking forward to seeing you on the birds. -- Mark D. Johns KØJM / MØGZO / ex-9H3DJ / ex-KØMDJ AMSAT Ambassador & News Service Editor Brooklyn Park, MN USA EN35hd ----------------------------------------------- "Heaven goes by favor; if it went by merit, you would stay out and your dog would go in." ---Mark Twain
On Thu, Oct 24, 2019 at 1:06 PM Gary Rogers via AMSAT-BB amsat-bb@amsat.org wrote:
I'm returning to satellite operations after being off the air (entire station disconnected) for over two decades and am looking to put my FT-736R back to use in the manner for which it was intended.?? However, while I'm OK with my 2M setup (rig to amp/pre-amp unit to Eggbeater) I'm less confident on 70cM, specifically how not to toast the mast mounted pre-amp. I know that I need to inject the voltage for the pre-amp using the little control box that came with the pre-amp (Mirage KP-2 series) but how do I ensure that the voltage drops when I transmit so the pre-amp is taken out-of-line??? Perhaps there is a FAQ or diagram for this out there somewhere?
Also, what is being used for CAT control these days if I'm using SatPC32 for tracking?
I feel like such a newb!
Thanks!?? -de Gary WA4YMZ
Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: https://www.amsat.org/mailman/listinfo/amsat-bb