I just arrived in Europe with a G5500 and was successfully able to convert the controller to 220v simply by moving the wire connected to pin 2 on the KT-30 transformer to pin 3. That's all it takes. If EA4CYG's wire is on pin 3, I would guess that someone has already converted it to 220v operation (perhaps without changing the plug to a European connector?).
To be sure that you connect to the correct pin, measure the resistance with an ohm meter between pins 0 and 2 and then 0 and 3. The resistance between 0 and 3 should be significantly more (almost double) the resistance between 0 and 2.
73, Bill NZ5N/OM3BD
PS - I am now QRV from OM land on HF but not yet on the sats, due to some antenna problems.
--- On Wed, 6/1/11, Bill Dzurilla billdz.geo@yahoo.com wrote:
From: Bill Dzurilla billdz.geo@yahoo.com Subject: RE: [amsat-bb] Re: G5500 change voltage supply To: amsat-bb@amsat.org, "Dee" morsesat@optonline.net Cc: ea4cyq@amsat.org Date: Wednesday, June 1, 2011, 1:43 PM The pdf say "G5500" in handwriting and I know a guy who says he did this mod on a G5500. But obviously the KT-30 must be a different transformer.
73, Bill
--- On Wed, 6/1/11, Dee morsesat@optonline.net wrote:
From: Dee morsesat@optonline.net Subject: RE: [amsat-bb] Re: G5500 change voltage
supply
To: "'Bill Dzurilla'" billdz.geo@yahoo.com,
amsat-bb@amsat.org
Cc: ea4cyq@amsat.org Date: Wednesday, June 1, 2011, 1:24 PM Look closer--Wrong rotor and I imagine you jump the other connections together to have the voltage correct. Again, Check the G5500 manual. Dee
-----Original Message----- From: amsat-bb-bounces@amsat.org [mailto:amsat-bb-bounces@amsat.org] On Behalf Of Bill Dzurilla Sent: Wednesday, June 01, 2011 12:53 PM To: amsat-bb@amsat.org Cc: ea4cyq@amsat.org Subject: [amsat-bb] Re: G5500 change voltage supply
Here is the mod to change Yaesu rotors to 220v: http://www.hamcity.com/store/pc/catalog/pdf/220vconversion.pdf
But perhaps yours has a different transformer if it
uses
pin 3 for 117v. In the mod, pins 0 and 3 are for 220v.
73, Bill NZ5N
Subject: [amsat-bb] G5500 change voltage supply
I have purchased a G5500. The control box have
a
117Vac label in the
real panel. I opened it and a wire is
connected
through the fuse to
the terminal number 3 of the KT-30 transformer
and the
other wire
through the main switch to the terminal number 1
of
the KT-30
transformer.
I am wondering how I should connect it to work
with
220Vac in Europe.
Thanks in advance. ea4cyq@amsat.org
Sent via AMSAT-BB@amsat.org. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the
amateur
satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb