CW Telemetry beacon, as decoded by FLDIGI here in CM98 on the 6/2 0600z pass. My rotor controller doesn't do flipped operation, so the 3rd frame got trashed by the rotor needing to swing around as the satellite passed through North. Some errors in the frames, but for the most part, during the frame itself, the signal was full quieting. It seemed like the very front of the frame (call sign?) was at a low power setting, then jumped up for the main part, and then at the end a few dits, seconds apart, at low power.

This was my second attempt (first success) at copying the beacon. Hope this helps,

Greg KO6TH

TRETET W 3 1 S NS 3 E SS* EEEI I IV E ESITT S*EEHIEH**WAE*H ERESIT<VE> * *I GI ZIEHTU IG Y 5 N V 4 6 4 4 3 1 3 7 8 7 4 C 0 1 7 0 1 2 4 T P 3 1 S 6 E <AA> EIH EET * *I T IEE THISI8 Y 5 N A ST EH * N1IM 7 8 7 4 C 0 1 7 0 1 2 4 T P 3 1 S 6 3 E SE ES SU T ET ERZ Y HE N V 4 6 E U 4 3 T 3 7 EE*EEE *III* 5HEN E G*G 0 0 N ATO <AA>W2 4 T P 3 I REDA E E5EI

Paul Stoetzer wrote:

Here is the telemetry frame decoded at about 0124Z in Washington, DC, USA (FM18lv):

ly5n v 427 372 370 85 c 014 0124 t p 31 s 6 3

73,

Paul Stoetzer, N8HM Washington, DC (FM18lv)

On Sun, Jun 1, 2014 at 9:29 PM, Paul Stoetzer [email protected] wrote:

...

Good evening,

It appears that the LituanicaSAT-1 FM transponder was off over North America at 0121Z. Strong signals were heard from the FM morse beacon. I will listen to my recording and decode the telemetry.

73,

Paul Stoetzer, N8HM Washington, DC (FM18lv)

---

Sent via [email protected]. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb

During the 0350Z pass, it appears that batteries discharged and LO-78 has reverted to CW FM. Telemetry indicates battery voltage of 6.9 Volts, and I believe it needs to recharge to 7.4 before the transponder is active.

73, Ken, W7KKE