I just tried to make some QSOs on the PO-101 pass starting around 22:04Z just a little bit ago. However, even though I could clearly hear the satellite for nearly it's entire pass, I could not seem to make it in. I'm not sure what wasn't configured right. This is my very first attempt with this satellite.

I am using a Yaesu FT-3DR with an Elk Antenna. I had very clear audio for much of the pass which is usually the more difficult part from experience. On that pass, I heard:

DN17 N6AJ DM05 KA7FVV K8YSE/7 DM43 WJ7WJ CN85

I'm not looking for LoTW confirmations, just if any of them heard me at all. I have five presets, all receive on 145.900 and transmit on 437.490, 437.495, 437.500, 437.505, and 437.510 MHz in that order. When pressing PTT, my radio showed the corresponding TX frequency and also TN 141.3 along with FM in the corner so I can't figure out what I was doing wrong especially during the peak when it should be close to being on frequency. I've been very successful with my set up on AO-91, AO-92, and SO-50 so it leaves me completely befuddled what I did wrong.

Confused, Loren K7IW