Guess I need Help with Fox-1A Software and IC910
Disappointing. I normally decode ARISS as well as local APRS. I heard the Voice ID gal very strongly, numerous times. The program was set to get audio from the SignaLink USB just as MixW and UISS are. Though they were no loaded.
On the IC910, I set "9600" on then after a while OFF then switched it back again later.
Got no decodes nor heard anything in the form of a signal except the Fox1 Safe Mode gal.
Can I get some guidance before nest pass?
thanks
You can't use regular audio, because it has the low frequencies we are using for the data filtered out. That includes the sound through your Signalink.
Use must either use an SDR source, or the audio from the data out pin on the back of your radio. Section 4.3 in the manual.
73, Drew KO4MA
-----Original Message----- From: AMSAT-BB [mailto:[email protected]] On Behalf Of Bob KD7YZ Sent: Thursday, October 08, 2015 8:08 PM To: AMSAT BB Subject: [amsat-bb] Guess I need Help with Fox-1A Software and IC910
Disappointing. I normally decode ARISS as well as local APRS. I heard the Voice ID gal very strongly, numerous times. The program was set to get audio from the SignaLink USB just as MixW and UISS are. Though they were no loaded.
On the IC910, I set "9600" on then after a while OFF then switched it back again later.
Got no decodes nor heard anything in the form of a signal except the Fox1 Safe Mode gal.
Can I get some guidance before nest pass?
thanks
-- 73, Bob KD7YZ www.qrz.com/db/kd7yz AmSat LM#901 _______________________________________________ Sent via [email protected]. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://www.amsat.org/mailman/listinfo/amsat-bb
Bob,
I have used sound card data at 9k6 with my IC910 for many years. I have found that using an interface with isolation transformers, works poorly.
Try wiring directly from the 9k6 pin of the sub band on the IC910 to the line-in of your desktop computer. I say desktop because many / most laptops have a microphone input only. That will probably not work.
Secondly, the 9600 setting on the radio is a transmit setting, not receive. If you want to try using the SignaLink to see if it will work, move the strap inside the SignaLink to the 9k6 pin of the radio.
I have a low pass here in the west at 01:30u and a good one at 03:00u. I will see what kind of success comes my way.
BOB KO6TZ
Disappointing. I normally decode ARISS as well as local APRS. I heard the Voice ID gal very strongly, numerous times. The program was set to get audio from the SignaLink USB just as MixW and UISS are. Though they were no loaded. On the IC910, I set "9600" on then after a while OFF then switched it back again later. Got no decodes nor heard anything in the form of a signal except the Fox1 Safe Mode gal. Can I get some guidance before nest pass? thanks -- 73,
Bob KD7YZ www.qrz.com/db/kd7yz AmSat LM#901
participants (3)
-
Andrew Glasbrenner -
Bob KD7YZ -
KO6TZ Bob