I have just downloaded and installed a new copy of SatPC32 12.8d and registered it. I'm using it with a new radio as well, an IC-9700. I did all the things I thought I remembered to setup the program and radio, and it sort of works....
My problem is when the program starts up, it will shift the radio into the Satellite Mode (good), and if I toggle the "C-/C+" CAT ON/OFF command, it will take the calculated frequency and set the radio correctly (good). However the radio is frequency is never updated after that, despite having a CAT Tuning Interval of 30 Hertz for SSB. If I toggle the "C" command off, then back on, it will update once, but never again. The other interesting thing is the manual tuning controls (the arrows to the right of the frequency display on SatPC32) work all the time. Click up 1k and the Downlink changes by 1k.
All of the above seems to make me think that the radio and SatPC32 have been setup correctly (and are talking to each other), but I don't understand why I just get an initial frequency correction and nothing else. Likely some bone-headed thing I have forgotten to do. Any ideas?
The other odd thing is that I can't fix the map to be stationary on the observer -- it always follows the satellite. I've stored that setting and restarted several times.
Thanks in advance!
73, Bob, WB4SON
Bob,
Make sure all your settings are correct.
http://www.dk1tb.de/IC9700_settings.htm
Dave-KB1PVH
Sent from my Galaxy S9
On Mon, Feb 3, 2020, 3:41 PM Bob via AMSAT-BB amsat-bb@amsat.org wrote:
I have just downloaded and installed a new copy of SatPC32 12.8d and registered it. I'm using it with a new radio as well, an IC-9700. I did all the things I thought I remembered to setup the program and radio, and it sort of works....
My problem is when the program starts up, it will shift the radio into the Satellite Mode (good), and if I toggle the "C-/C+" CAT ON/OFF command, it will take the calculated frequency and set the radio correctly (good). However the radio is frequency is never updated after that, despite having a CAT Tuning Interval of 30 Hertz for SSB. If I toggle the "C" command off, then back on, it will update once, but never again. The other interesting thing is the manual tuning controls (the arrows to the right of the frequency display on SatPC32) work all the time. Click up 1k and the Downlink changes by 1k.
All of the above seems to make me think that the radio and SatPC32 have been setup correctly (and are talking to each other), but I don't understand why I just get an initial frequency correction and nothing else. Likely some bone-headed thing I have forgotten to do. Any ideas?
The other odd thing is that I can't fix the map to be stationary on the observer -- it always follows the satellite. I've stored that setting and restarted several times.
Thanks in advance!
73, Bob, WB4SON _______________________________________________ Sent via AMSAT-BB@amsat.org. AMSAT-NA makes this open forum available to all interested persons worldwide without requiring membership. Opinions expressed are solely those of the author, and do not reflect the official views of AMSAT-NA. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: https://www.amsat.org/mailman/listinfo/amsat-bb
participants (2)
-
Bob -
Dave Webb KB1PVH