Hello Will,

I would consider re-tapping to the next size larger with a SAE thread, then add SAE machine screws or.. solder directly to the stripped terminal after removing the metric machine screw.

I infrequently use these terminals, rather I have a short pigtail with a connector.

Stan, W1LE Cape Cod FN41sr

On 6/11/2011 5:00 PM, William Liporace - WC2L wrote:

Good Afternoon,

I have a Yaesu G-5400B Controller with a couple of semi stripped set screw. I am wondering if someone has replacement terminal strips. Has anyone one come up with a decent replacement scheme?

TNX Will WC2L

---

Sent via [email protected]. Opinions expressed are those of the author. Not an AMSAT-NA member? Join now to support the amateur satellite program! Subscription settings: http://amsat.org/mailman/listinfo/amsat-bb